Specifications:

• RH-100: 1,000W
• with or without ground(earth)
• blister card packing, 50PCS/CTN
• with CE, BSMI approval

Features:

 Instructions: 

1.          Place the container on a heat resistant insulating pad to avoid heat transfer to the worktop.

2.          Place the immersion heater in your container by hanging it over the lip (side) on the inside of the mug or pot.

3.          In general, immersion heaters may only be used to heat water and must not be used to heat oil or other liquids.

4.          Fill the container to the designated water level on your immersion heater (do not submerge the heater and make sure the coils are not exposed to air). The water level must not exceed the maximum water level mark or fall below the minimum water level mark as otherwise the appliance will be damaged.

5.          The immersion heater is equipped with fuse which, to protect the users, blows out in case of dry use.

6.          Always place the item in liquid before putting the plug into the outlet. Plug your immersion heater into the power outlet.

7.          When the liquid is hot, unplug the immersion heater from the outlet and only take it out of the water about 15 seconds after having unplugged it. Always remove the plug from outlet before removing the appliance from the liquid.

Certificate:

• CE
• BSMI
• LFGB
• RoHS
• California 65

Order Information:

• Minimum Order: Negotiable
• FOB: SHENZHEN, CHINA